Table of Contents
Advertisement
ProCore Edge
Display
Message
(Name)
Module Memory
Issue
Module OCP
Tripped
MODULE
OVER TEMP
(Module /
Charger Over
Temperature)
Module OVP
Tripped
MODULE TYPE
ERR
(Module
Installation
Type)
No Battery
Configuration
No Modules
Webasto Charging Systems, Inc.
Message
Description
type
The module had a memory
Fault
related error.
There was an error in the
Fault
over-current protection
module.
The air intake is blocked.
The system board
temperature sensor is
above 80° C.
Fault
The module temperature is
too high to charge.
The module failed.
There was an error in the
Fault
over-voltage protection
module.
The power module type
does not match the factory
configuration (cabinet volt-
Fault
age) settings, or incompat-
ible modules were installed
together.
The parameters have not
been configured for the
Fault
voltage mode charge.
No power modules are
installed.
Fault
No CAN or BMID messages
received when connected.
Installation, Operations, Service & Maintenance
Page 59 of 112
Action(s)
Call Webasto service.
Check that the battery
voltage is within range for
the charger.
Check for obstructed air flow.
Remove the blockage.
Replace the power module.
Check that the battery
voltage is within range for
the charger.
Install the correct
power module.
Call Webasto service.
Configure the voltage
mode settings on the
charger, using the ProCore
mobile app.
Call Webasto service.
Check the comm wiring.
Part Number 5911110 A02
Advertisement
Table of Contents
