Webasto ProCore Edge Installation, Operation, Service And Maintenance Instructions page 86

Installation, Operations, Service & Maintenance
Procedure:
1. Perform the lockout/tagout
procedure before servicing the
charging station.
2. Open the front door and unplug the
seven cables (J1 – J7) as shown
below.
3. Remove the seven screws as shown
to the right, then remove the PCBA.
4. Install the new/replacement PCBA
and tighten the screws with 0.44 lb-ft
(0.3 Nm) of torque.
5. Plug in cables J1 – J7 as shown below.
Part Number 5911110 A02 Page 86 of 112
Fig. 58 – PCBA 3/4 View
Webasto Charging Systems, Inc.
ProCore Edge
Fig. 59 –
PCBA Rear
Facing View