Table of Contents
Advertisement
Installation, Operations, Service & Maintenance
7. Single-Cable Connection
For a single-cable connection, start by disconnecting the end of the cable
from the termination block located at the very bottom of the charger. Then
unplug the communications, starting from the bottom power module, until
the module to be replaced has been disconnected.
NOTE
The ribbon cable has a red edging to denote Pin 1.
While facing the module, always insert the connectors so the cable red line is on
the left.
Part Number 5911110 A02
Fig. 41 – Single Cable Connection
Page 72 of 112
ProCore Edge
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the ProCore Edge and is the answer not in the manual?
Questions and answers