7.1
Module Removal / Installation
Required Tools and Supplies
Anti-static wrist strap and conductive workbench pad (recommended)
•
7.1.1
Module Removal
1. Power down the module using the power button on the front panel of the module to be removed.
1U module shown
2. Press the green latch inward (see Letter A) and lower the lever in front of the module (see Letter B).
3. Pull out the module from the chassis (see Letter C).
Note: To keep the system operating within its thermal limits, module bays must be populated with either a
module or module blank when any of the installed modules are operational.
7.1.2
Module Installation
Required Tools and Supplies
Anti-static wrist strap and conductive workbench pad (recommended)
•
1U module shown
1. Ensure that the lever in front of the module is lowered. If not, press the green latch inward and lower
the lever (see Letter A).
2. Align the module to its corresponding bay and slide it into the chassis until the key pins in the lever
are inside the chassis inner wall key holes.
3. Raise the lever to secure the module (see Letter B).
112
Intel® Server D50DNP Family Integration and Service Guide
Figure 125. Removing a Module
Figure 126. Installing a Module