Table of Contents
Advertisement
3.2.2
Module Installation
Required Tools and Supplies
Anti-static wrist strap and conductive workbench pad (recommended)
•
1U module shown
1. Ensure that the lever in front of the module is lowered. If not, press the green latch inward and lower
the lever (see Letter A).
2. Align the module to its corresponding bay and slide it into the chassis until the key pins in the lever
are inside the chassis inner wall key holes.
3. Raise the lever to secure the module (see Letter B).
3.3
Air Duct Removal / Installation
To maintain system thermals, the air duct must always be in place when the module is operational. Removal
of the air duct is necessary when installing or replacing any system component within the module.
Air duct construction and attachment method are similar for all half-width air-cooled modules
D50DNP1MHCPAC, D50DNP1MHEVAC, and D50DNP2MHSVAC. The D50DNP2MFALAC module is slightly
different and the changes in construction are reflected in the corresponding illustrations.
Note: Air ducts are not used with liquid-cooled modules.
Required Tools and Supplies
•
Anti-static wrist strap and conductive workbench pad (recommended)
Intel® Server D50DNP Family Integration and Service Guide
Figure 60. Installing a Module
61
Advertisement
Table of Contents
