1. Align the riser card to the riser slot on the server board (see Letter A).
2. Carefully push down on the riser assembly until the riser card is securely seated in the riser slot.
3. Ensure that the screw holes of the riser assembly are aligned with the mounting holes of the module.
4. Using Phillips screwdriver #2 tighten the captive screw at the back of the riser assembly to 5 in-lb.
(see Letter B)
5. Using Phillips screwdriver #1 install two screws to secure the riser assembly to the front of the
module. Tighten to 5 in-lb. (see Letter C).
3.4.5
MCIO* Riser Assembly Installation
1U air-cooled module shown
1. Align the riser card to the riser slot on the server board and tilt the riser assembly down (see Letter B).
2. Carefully push down on the riser assembly until the riser card is securely seated in the riser slot (see
Letter C).
Intel® Server D50DNP Family Integration and Service Guide
Figure 74. Installing the MCIO Riser Assembly
1U air-cooled
module shown
Figure 75. Securing the MCIO* Riser Assembly
69