Table of Contents
Advertisement
Intel
®
Server System R1000WT Product Family System Integration and Service Guide
3.2 Power Supply Module – Installation / Removal
3.2.1
Power Supply Module Installation
•
(If installed) Remove the insert from the chassis power supply bay
•
Insert the power supply module into the power supply bay
•
Push the power supply module into the bay until it locks into place
3.2.2
Power Supply Module Removal
Caution: The power supply is only hot-swappable (system does not have to be powered down) if the system is configured
with two power supply modules operating in a 1+1 Redundant configuration only.
Systems with a single power supply installed or a system operating in a 2+0 non-redundant power mode, MUST be
powered OFF before removing the power supply module from the system.
•
Detach the power cord from the power supply to be removed.
•
Using the handle, pull the power supply module from the system while pushing the green latch in the direction
shown.
Rev 2.2
Figure 57. Power Supply Module Installation
Figure 58. Power Supply Module Removal
37
Advertisement
Table of Contents
