Table of Contents
Advertisement
Intel® Server D50DNP Family Integration and Service Guide
Figure 137. Installing Processor Carrier Clip onto Processor – Part 2
1. Align the Pin 1 indicator on the processor carrier clip with the Pin 1 indicator of the processor.
2. With the processor still in its shipping tray, place the processor carrier clip over the processor.
3. Gently press down simultaneously on two opposite sides of the processor carrier clip until it clicks in
place.
4. Repeat step 3 for the other two sides.
5. Locate the processor heat sink. To avoid damage, grasp it by its narrower sides as shown.
6. Place the heat sink bottom side up onto a flat surface.
If reusing an existing heat sink
Properly clean off existing thermal interface material from the bottom of the heat sink.
•
Apply new TIM (Honeywell PTM7000*).
•
If using a new heat sink, remove the plastic protective film from the Thermal Interface Material (TIM).
Figure 138. Processor Heat Sink Handling
119
Advertisement
Table of Contents
