Add-In Card Replacement For Liquid-Cooled Modules (D50Dnp1Mhcplc And D50Dnp1Mfallc Modules) - Intel D50DNP Series Integration And Service Manual

7.8 Add-In Card Replacement for Liquid-Cooled Modules (D50DNP1MHCPLC and
D50DNP1MFALLC Modules)
1U liquid-cooled modules can accommodate up to two low-profile liquid-cooled PCIe* add-in cards. These
models are supported:
• NVIDIA* MCX653105A-HDAL
NVIDIA* MCX653106A-HDAL
•
NVIDIA* MCX75310AAS-HEAL
•
• NVIDIA* MCX75310AAS-NEAL
Required Tools and Supplies
Replacement liquid-cooled PCIe* add-in card
•
New thermal strips from the D50DNP M.2 heatsink liquid-cooled kit DNPM2LCHS (recommended)
•
• Anti-static wrist strap and conductive workbench pad (recommended)
Phillips* head screwdriver #1
•
Note: The following steps to install PCIe* add-in card should be performed along with the instructions for
the add-in card.
1. Prepare the replacement PCIe* add-in card by attaching the thermal pad to the ASIC or heat spreader
as instructed in the card documentation.
2. Remove three crews securing the PCIe add-in card to the conduction plate.
3. Remove the selected riser assembly following procedure described in
4. Pay attention not to damage or displace the thermal strips attached to the conduction plate.
5. Remove the PCIe add-in card following the description in
6. Clean any residue left on the conduction plate from the thermal pad attached to the add-in card ASIC.
5. Install the replacement PCIe* add-in card following the procedure described in
6. Install the riser assembly into the module following the procedure described in
7. Secure the PCIe add-in card to the conduction plate with three screws. Tighten to 5 in-lb.
Intel® Server D50DNP Family Integration and Service Guide
Section 7.5.1
Section 7.5.3.
Section
Section
or Section 7.5.2.
7.5.3.
7.5.6.
167