Table of Contents
Advertisement
3. Disconnect the riser board from the riser slot connector by lifting it up.
4. Tilt the riser assembly on its side (see Letter C) to make room to install the add-in card.
7.5.3
PCIe* Add-In Card Replacement
1U air-cooled
module shown
1. Carefully remove the add-in card from the PCIe* slot (see Letter A).
2. If not installing a new add-in card, carefully install the original metal filler plate over the opening on
the metal frame of the riser assembly (see Letter B).
Intel® Server D50DNP Family Integration and Service Guide
Figure 192. Tilting MCIO* Riser Assembly
Figure 193. Add-In Card Removal
149
Advertisement
Table of Contents
