7.16 Internal Chassis Rail Replacement; Figure 260. Removing Internal Chassis Rail - Intel D50DNP Series Integration And Service Manual

7.16 Internal Chassis Rail Replacement

The Intel® Server System D50DNP includes internal rails to support 1U modules in the upper part of the
chassis. If the internal rails become damaged or worn out, this section provides the instructions necessary to
replace them.
Required Tools and Supplies
• Chassis rail spare kit FCXX1USPPRT
Anti-static wrist strap and conductive workbench pad (recommended)
•
Note: To maintain optimal performance of the system, Intel recommends replacing ALL internal rails at once.
1. Ensure that the system power is off and then disconnect the power supply cord(s).
2. Remove the server chassis from the rack and place it on a flat surface.
Important Safety Notes: Due to the weight of a fully configured system, Intel recommends:
Use a mechanical lift to aid with the removal of the system from the rack.
•
Or remove all installed modules from the system and use at least two people to remove the
•
system from the rack.
3. Remove the modules from the bays selected for service (see
4. Locate the internal rails in the upper part of the inner walls of the chassis.
5. Release the rail latch (see Letter A).
6. Slide the rail towards the front of the chassis to remove it (see Letter B).
190
Intel® Server D50DNP Family Integration and Service Guide

Figure 260. Removing Internal Chassis Rail

Section 7.1.1).