Figure 135. Processor Carrier Clip Removal From Phm Assembly; Figure 136. Installing Processor Carrier Clip Onto Processor - Part 1 - Intel D50DNP Series Integration And Service Manual

Figure 135. Processor Carrier Clip Removal from PHM Assembly

3. Return the lever to the original position (see Letter C).
4. Detach the processor carrier clip from the heat sink.
• Unlatch the hook on each corner of the processor carrier clip (see Letter D).
Lift the clip from the heat sink (see Letter E).
•
7.3.1.3 PHM Reassembly
To properly reassemble the PHM and install it onto the server board, the procedures described in the
following sections must be followed in the order specified. These instructions assume that the processor
heat sink (new or reuse of existing) has the necessary thermal interface material (TIM) Honeywell PTM7000*
already applied to the clean bottom of the heat sink.
Caution: Full ESD precautions should be followed to perform assembly and installation of the PHM to the
server board. Wear ESD gloves to prevent electrostatic damage and oxidation or foreign materials on
processor package and land pads.
Each component within the PHM assembly includes a Pin 1 indicator. Pin 1 indicator alignment between all
components is required throughout the assembly process.
Figure 136. Installing Processor Carrier Clip onto Processor – Part 1
118
Intel® Server D50DNP Family Integration and Service Guide