Table of Contents
Advertisement
Intel® Server System M50FCP1UR System Integration and Service Guide
6.3
Memory Module Replacement
Required Tools and Supplies
Anti-static wrist strap and conductive workbench pad (recommended)
•
Replacement memory module
•
Note: Replacement DDR5 DIMMs must be identical or have "Like DIMM" attributes defined in Appendix C2.
See Appendix C for memory population rules.
Average Time to Complete: ~ 5 minutes (Complete Intel® Optane™ PMem 300 series replacement and setup
is longer).
Procedure Prerequisites
•
Memory modules are NOT hot-swappable. The system must be powered down and unplugged from
the AC power source before replacing a faulty memory module from the system.
The following figures show standard DDR5 DIMMs, but the physical replacement procedure is the same for
both standard DDR5 DIMMs and Intel® Optane™ PMem modules.
DDR5 DIMM and Intel Optane PMem devices are commonly referred to as "memory module" in the following
instructions.
1. Power off the system and disconnect the system power cords.
2. Remove the top cover panels (see
3. Identify and locate the memory module to be removed.
4. Ensure that the ejection tabs of adjacent memory slots are closed.
5. Open the ejection tabs at both ends of the selected memory slot (see Letter A). The memory module
lifts slightly out from the memory slot.
6. Holding the memory module by its edges, lift it away from the slot (see Letter B).
60
Figure 70. Memory Module Removal
Section
6.1.1).
Advertisement
Table of Contents
