Mcio* Riser Assembly Removal; Figure 70. Removing The Screws For Mcio Riser Assembly; Figure 71. Tilting The Mcio* Riser Assembly - Intel D50DNP Series Integration And Service Manual

3.4.2

MCIO* Riser Assembly Removal

1U air-cooled
module shown
1. Using Phillips screwdriver #1 remove two screws that secure the riser assembly to the front of the
module (see Letter A).
Using Phillips screwdriver #2 loosen the captive screw at the back of the riser assembly. (see Letter B)
2.
3. Disconnect the riser board from the riser slot connector by lifting it up.
4. Tilt the riser assembly on its side (see Letter C) to make room to install the add-in card. Refer to the
following section for add-in card installation.
Intel® Server D50DNP Family Integration and Service Guide

Figure 70. Removing the Screws for MCIO Riser Assembly

Figure 71. Tilting the MCIO* Riser Assembly

67