BODY AND TRIM
TWO-PASSENGER CANOPY WITH VISAGE DISPLAY UNIT INSTALLATION
1.
Put the tabs of the display unit support (12) into the front canopy struts (Figure 4-19, Page 4-23).
2.
Install the display unit support onto the front canopy struts.
3.
Connect the display unit harness (11).
4.
Install the Visage display unit (VDU) (10) onto the display unit support.
5.
Install the screws (9). Tighten the screws to 24 lb·in (2.7 N·m).
6.
Make sure that the strut harness is routed correctly.
Figure 4-19 Visage Display Unit Installation
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Two-Passenger - Canopy
Page 4-23
4