Fuel Level Sending Unit; Fuel Level Sending Unit Removal; Fuel Level Sending Unit Installation; Ignition Coil And Charge Coil - Club Car XRT 950 2009 Maintenance And Service Manual

12

Fuel Level Sending Unit

WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2. Install the fuse cover and lower the seat.
FUEL LEVEL SENDING UNIT
See General Warning on page 1-2.
TESTING THE FUEL LEVEL SENDING UNIT
See Test Procedure 18 – Fuel Level Sending Unit on page 11-33.

FUEL LEVEL SENDING UNIT REMOVAL

See Fuel System section.

FUEL LEVEL SENDING UNIT INSTALLATION

See Fuel System section.

IGNITION COIL AND CHARGE COIL

See General Warning on page 1-2.
It is recommended that the ignition coil and charge coil be thoroughly tested prior to replacement.
TESTING THE IGNITION COIL AND CHARGE COIL
See Test Procedure 12 – Ignition Spark on page 11-29. See also Test Procedure 10 – Charge Coil on page 11-28.

IGNITION COIL AND/OR CHARGE COIL REMOVAL

The ignition coils are located under the flywheel shroud of the engine and the charge coil is located behind the flywheel.
Replacement requires the removal and installation of the engine. See Section 13 – Engine. . It is recommended to
thoroughly test the coils prior to replacement.
Refer to the engine manual for additional testing, removal, disassembly, and installation procedures. See
the Briggs & Stratton Vanguard engine manual (CC P/N 103568101).
Page 12-10 2009-2012 XRT 950 Maintenance and Service Manual
ELECTRICAL COMPONENTS