Table of Contents
Advertisement
GASOLINE VEHICLE - FUEL SYSTEM
FUEL FILTER INSTALLATION
CAUTION
• Fuel filter flex hoses are keyed to aid proper installation into fuel pump module.
NOTE: The fuel filter is keyed to the fuel pump module to prevent incorrect assembly.
The inlet and outlet flex hoses are keyed to the fuel filter ports to prevent incorrect assembly.
1.
Orient fuel filter (4) and insert into fuel pump module (1) until fully seated (Figure 21-24, Page 21-25).
3052E
Figure 21-24 Fuel Filter Installation
2.
Connect flex hoses (2 and 3) to the fuel filter.
2.1.
Orient flex hoses with matching port in filter and push each hose end straight into filter until fully seated.
2.2.
Push hose retainer clip straight into filter until fully seated.
3.
Install fuel pump module. See Fuel Pump Module Installation.
4.
Connect the battery and spark plug wire.
5.
Set the Forward/Neutral/Reverse control (FNR) to N.
6.
Chock the wheels.
7.
Set the Maintenance/Operate switch to MAINTENANCE.
8.
Start the engine and check for fuel leaks. See following DANGER.
DANGER
• Repair all fuel leaks before operating the vehicle.
9.
If no leaks are found, set the Maintenance/Operate switch to OPERATE.
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
21
Fuel Filter
Page 21-25
Advertisement
Table of Contents
Troubleshooting
