Club Car Precedent Villager 2 2019 Maintenance And Service Manual page 430

21
Fuel Pump Module
2. Disconnect the battery.
3. Clean the top of the fuel tank and fuel pump module.
4. With a marker pen, make a mark across the top of the fuel pump module and onto the tank to note orientation
before removal.
5. Remove the screws (1) (Figure 21-19, Page 21-18).
6. Remove the fuel tank retaining strap (2).
7. Disconnect the wire harness from the fuel pump module plug (3).
WARNING
• Fuel may be under pressure. Use extreme caution when disconnecting fuel line to prevent the spray of
fuel onto hot engine. See Relieving Fuel Pressure.
• Carefully drain any fuel remaining in the hose or pump module into an approved container. Add
drained fuel back into fuel tank or dispose of properly.
8. Disconnect the fuel line (4) and drain into an appropriate container. See Fuel Line Removal.
9. Remove the screws (5).
10. Remove the ground wire (6) and hold down ring (7).
11. Lift the fuel pump module (8) out of fuel tank and drain into an appropriate container.
NOTE: If equipped with a fuel level sending unit, carefully maneuver module so as to avoid damaging the float
arm mechanism.
12. Discard the fuel module o-ring (9).
Page 21-18 2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Figure 21-19 Fuel Pump Module Removal
GASOLINE VEHICLE - FUEL SYSTEM