BODY AND TRIM
REAR BEAUTY PANEL (2+2 VEHICLES)
2+2 rear body component procedures.
1
3
2656G
Rear Beauty Panel Removal
1.
Remove the front seat bottom.
2.
Remove the rear seat assembly.
3.
Remove the forward / neutral / reverse (FNR) control.
4.
Remove the screws (1) (Figure 4-55).
5.
Disengage the two body clips (2) under the rear of the beauty panel (3) from the slots in the rear underbody (4).
6.
Remove the rear beauty panel from the rear underbody.
Rear Beauty Panel Installation
1.
Install the rear beauty panel (3) on the rear underbody (4). Make sure body clips (2) on the rear of the beauty
panel engage the slots in the rear underbody(Figure 4-55).
2.
Install the screws (1). Tighten the screws to 44 lb·in (5 N·m).
3.
Install the FNR control.
4.
Install the rear seat assembly.
5.
Install the front seat bottom.
2
Figure 4-55 2+2 Rear Beauty Panel
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Villager 4 - Rear Body
4
Page 4-57
4