Table of Contents
Advertisement
20
Snubber
SNUBBER
NOTE: The snubber is installed on the gasoline vehicle only.
SNUBBER REMOVAL
1.
Support the powertrain with a floor jack under the engine pan (1) so that the snubber (2) is raised slightly and
does not rest on the vehicle frame (Figure 20-9, Page 20-8).
2.
Remove the two bolts (3) and two lock nuts (4) securing the snubber bracket (5) to the engine pan.
3.
Slide the snubber and snubber bracket assembly toward the battery to remove it from vehicle.
4.
Slide the snubber off the snubber bracket.
SNUBBER INSTALLATION
1.
Slide the snubber (2) onto the snubber bracket (5) (Figure 20-9, Page 20-8).
2.
Install the snubber bracket and snubber assembly onto engine pan (1).
3.
Install the bolts (3) and lock nuts (4). Tighten the lock nuts (4) from 20 to 25 ft·lb (27.1 to 33.9 N·m).
Page 20-8
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Figure 20-9 Snubber
GASOLINE VEHICLE - ENGINE
Advertisement
Table of Contents
Troubleshooting
