Cleaning The Vehicle Interior; Body Repair; Stress Lines Or Streaks; Minor Impact Damage/Deformations - Club Car Precedent Villager 2 2019 Maintenance And Service Manual

4

Cleaning the Vehicle Interior

CLEANING THE VEHICLE INTERIOR
CAUTION
• Moisture will cause electrical component damage. Do not use a pressure washer or steam cleaner
to clean the vehicle.
• To prevent damage to the vehicle when removing difficult stains or heavy soiling, remove the seat
bottom from the vehicle first.
To preserve seat appearance, clean regularly with mild soap or detergent applied with a sponge or soft cloth. Use a
soft bristle brush to clean areas that are especially soiled. Use the following guidelines:
Light Soiling: A solution of 10% liquid dish soap and warm water applied with a soft, damp cloth is recommended.
A soft bristle brush may be used if necessary. Wipe off any residue with a water dampened cloth.
Difficult Stains: Dampen a soft, white cloth with a solution of 10% household bleach (sodium hypochlorite) and
90% water. Rub gently to remove stain, then rinse with a water dampened cloth to remove bleach concentration.
More Difficult Stains: Perform previous procedure using full-strength bleach, or allow bleach to puddle on
affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove any remaining bleach
concentration.

BODY REPAIR

STRESS LINES OR STREAKS

Repeatedly flexing the Surlyn
1. Hold a heat gun 12 inches (30 cm) away from the affected area, with the gun on its lowest heat setting.
2. Slowly wave the heat gun back and forth over the affected area until the streak fades.
CAUTION
• Holding the heat gun too close to the body could melt the body or damage the finish. Do not hold the
heat gun closer than 6 inches (15 cm) to the body.
3. It may be necessary to move the gun closer to the body to fade the streak. Do not hold the gun closer than
6 inches (15 cm) to the body.

MINOR IMPACT DAMAGE/DEFORMATIONS

Minor impact damage to a Surlyn
lines. To remove deformations resulting from minor impact damage:
1. Hold a heat gun 12 inches (30 cm) away from the affected area, with the gun on its lowest heat setting.
2. Periodically remove the heat gun and bend the body, using a push block, in the opposite direction of the
deformation.
Page 4-2 2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
® body can cause white stress lines or streaks in the finish. To remove them:
® body can be repaired using a procedure similar to the one used to remove stress
BODY AND TRIM