9
Panhard and Bracket
PANHARD AND BRACKET
PANHARD AND BRACKET REMOVAL
1.
Disable the vehicle.
2.
Electric Vehicle: Disconnect the batteries and discharge the controller.
Gasoline Vehicle: Disconnect battery and spark plug wire.
3.
Remove the bolts (1) (Figure 9-4, Page 9-4).
4.
Remove the panhard (2).
5.
Remove the bolts (3) and nuts (4).
6.
Remove the bracket (5).
PANHARD AND BRACKET INSTALLATION
1.
Put the bracket (5) into position on the frame (Figure 9-4, Page 9-4).
2.
Install the bolts (3) and nuts (4). Tighten the bolts to 18.5 lb·ft (25 N·m).
3.
Put the panhard (2) into position on the vehicle.
4.
Install the bolts (1). Tighten the bolts to 92 lb·ft (125 N·m).
5.
Electric Vehicle: Connect the batteries.
Gasoline Vehicle: Connect battery and spark plug wire.
Page 9-4
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Figure 9-4 Panhard and Bracket
REAR SUSPENSION