Rack And Pinion Installation - Club Car Precedent Villager 2 2019 Maintenance And Service Manual

STEERING AND FRONT SUSPENSION
3. Remove the front bumper.
4. Remove the tie rod end retaining nuts (1) (Figure 7-6, Page 7-6).
5. Remove the tie rod ends (2) from the spindle tabs (3).
6. Remove the bolts (4).
7. Remove the bolt (5) from the universal joint (6).
8. Remove the universal joint from the pinion shaft (7).
9. Remove the rack and pinion assembly.

RACK AND PINION INSTALLATION

1383B
1. Apply a light coat of anti-seize lubricating compound to the pinion shaft (7) (Figure 7-7).
2. Install the universal joint (6) onto the pinion shaft.
3. Install the screws (4). Tighten the screws to 22 lb·ft (30 N·m).
4. Install the bolt (5). Tighten the bolt to 18.4 lb·ft (25 N·m).
5. Install the tie rod ends (2) into the spindle tabs (3)
6. Install the retaining nuts (1).
WARNING
• Do not operate vehicle until toe-in is adjusted and ball joints are secured.
7. Adjust the toe-in. See Tow-in Adjustment.
8. Electric Vehicle: Connect the batteries.
Gasoline Vehicle: Connect the battery and spark plug wire.
5
7
4
Figure 7-7 Rack and Pinion Installation
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
6
2
3
1
7
Rack and Pinion
Page 7-7