Table of Contents
Advertisement
19
Neutral Lockout Limit Switch
4.
Remove the nuts (2) and washers (3).
5.
Remove the neutral lockout limit switch.
NEUTRAL LOCKOUT LIMIT SWITCH INSTALLATION
1.
Install the neutral lockout limit switch (1) on the bolts (Figure 19-27, Page 19-26).
CAUTION
• Do not overtighten the nuts. If the nuts are over tightened, the limit switches could be damaged.
2.
Install the washers (2) and nuts (3). Tighten the nuts to 4 in·lb (0.45 N·m).
3.
Set the Forward/Neutral/Reverse control (FNR) to R.
4.
Make sure that both limit switches actuate.
5.
Connect the black/yellow wire to the COM1 terminal (4) (Figure 19-28, Page 19-26).
6.
Connect the green wire to the NO3 terminal (5).
7.
Connect the white/black wire to the NC2 terminal (6).
Page 19-26
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Figure 19-27 Neutral Lockout Limit Switch Installation
Figure 19-28 Neutral Lockout Limit Switch Terminals
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
Advertisement
Table of Contents
Troubleshooting
