Installation Procedure; Removing The Rear Panel And Covers - Agilent Technologies E4402BU Option H3B Installation Manual

E4402BU Option H3B

Installation Procedure

This installation procedure provides instructions for installing the Option H3B into a
E4402B ESA Spectrum Analyzer. The Option H3B can occupy Slot 5 or 6. Refer to the
E4402B Option H3B User's and Service Guide (E4401-90511) for performance verification.
Follow the steps outlined below to install the Option IF Output retrofit kit.

Removing the Rear Panel and Covers

NOTE Keep all of the hardware (screws, nuts, etc.) for re-use when installing the
assemblies.
1. Remove the rear frame on the ESA using a #20 Torx driver (4 screws). Refer to
Figure 1 Rear Panel
Installation Guide
Installation Procedure
Figure 1.
5