Peqie -- Set Enabled Parameter For Specified Parametric Eq Input Stage; Peqif -- Set Frequency Parameter For Specified Parametric Eq Input Stage - Polycom Vortex EF2241 Programming Manual

This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Set bandwidth of parametric EQ on
input 3 , band 2 to 40 1/100th
B01PEQIB3,2,40
octaves.
Query current bandwidth setting of
B01PEQIBB,1,?
parametric EQ on input B , band 1.
8.120. PEQIE -- Set Enabled Parameter for Specified
Parametric EQ Input Stage
This command sets or queries the enabled parameter (0 = filter is disabled, 1 = filter is enabled) for the
parametric equalizer (EQ) filters on input channels 1-4, A-D, and T . Each channel has five bands of
parametric EQ that can be independently controlled.
This command has the same format and restrictions as the
parameter, the enabled status, is specified instead of all the parameters. See the
information. To set the enabled parameter for an output parametric EQ filter, use the
set all the parameters for an output parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Enable parametric EQ on input 3 ,
B01PEQIE3,2,1
band 2.
Query enabled status of parametric
B01PEQIEB,1,?
EQ on input B , band 1.
8.121. PEQIF -- Set Frequency Parameter for Specified
Parametric EQ Input Stage
This command sets or queries the frequency parameter (in Hz) for the parametric equalizer (EQ) filters on
input channels 1-4, A-D, and T . Each channel has five bands of parametric EQ that can be independently
controlled.
Status Message
B01PEQIB3,2,40
B01PEQIBB,1,b , where b is the current setting
of the bandwidth parameter for the parametric EQ
on input B , band 1. If the bandwidth parameter of
this filter is set to the same value given in the
example above, then the status message will be
B01PEQIBB,1,40 .
command except that only one
PEQIA
command.
PEQOA
Status Message
B01PEQIE3,2,1
B01PEQIEB,1,e , where e is the current setting
of the enabled parameter for the parametric EQ
on input B , band 1. If the enabled parameter of
this filter is set to the same value given in the
example above, then the status message will be
B01PEQIEB,1,1 .
command for more
PEQIA
command. To
PEQOE