Gaindt -- Set Dial Tone Gain; Gaingil -- Set Gain Of Line Inputs As A Group - Polycom Vortex EF2241 Programming Manual

B01GAINDIT? Query incoming DTMF tone gain.

8.57. GAINDT -- Set Dial Tone Gain

This command sets the gain of the dial tone received from the phone interface.
This command is an integer command. See
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAINDT6 Set dial tone gain to 6 dB.
B01GAINDT>3 Increase dial tone gain by 3 dB.
B01GAINDT? Query dial tone gain.

8.58. GAINGIL -- Set Gain of Line Inputs as a Group

This command sets the gains of all the line inputs simultaneously. This is different from using a wildcard, *
with the command because that command sets all the mic and line inputs together, while the
GAINI
GAINGIL sets only the line inputs.
This command will generate acknowledgements from each of the line inputs separately.
This command is an integer command. See
minimum and maximum values for this command are 0 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAINGIL7 Set gain of all line inputs to 7 dB.
B01GAINDITx , where x is the new value of
the incoming DTMF tone gain. If this command
was issued after the example above, then the
status message would be B01GAINDIT9 .
Section 6.2 for more information on this type of command. The
Status Message
B01GAINDT6
B01GAINDTx , where x is the new value of the dial tone
gain. If this command was issued after the example above,
then the status message would be B01GAINDT9 .
B01GAINDTx , where x is the new value of the dial tone
gain. If this command was issued after the example above,
then the status message would be B01GAINDT9 .
Section 6.2 for more information on this type of command. The
Status Message
B01GAINIA7
B01GAINIB7
B01GAINIC7
B01GAINID7