Error -- Enable Or Disable Error Messages - Polycom Vortex EF2241 Programming Manual

generated if a command attempts to exceend 100 percent utilization.
If the feature is enabled, then a DSPLOAD status message will be generated automatically any
DSPAUTO
time the percent utilization changes.
Example Description
Query percentage of variable DSP
B01DSPLOAD?
resources used.

8.46. ERROR -- Enable or Disable Error Messages

This command sets or queries whether or not error messages for non-fatal errors are reported via RS-232
and the digital bus.
If an error is generated and error messages are enabled, a status message will be automatically generated of
the form ' B01ERROR#xxx ', where xxx is a three digit number indicating the error code. The following table
lists the non-fatal error messages that can be generated by the Vortex.
Error Number Description
Unrecognized command.
ERROR#001
Syntax error in command.
ERROR#002
Attempt to change parameter that is locked via
ERROR#004
Attempt to unlock
ERROR#005
This error occurs as the result of an
would remove a microphone from an automixer where it is assigned as the "last mic on"
ERROR#040
and the automixer is set to manual "last mic on" mode.
This error occurs as the result of an
would remove a microphone from an automixer where it assigned as the chairman
ERROR#041
imcrophone and the automixer has chairman mode enabled.
This error occurs as the result of an
attempts to set "last mic on" mode to manual, but the last mic number is set to a
ERROR#042
microphone that does not belong to the specified automixer.
This error occurs as the result of an
attempts to set a "last mic on" number that does not belong to the specified automixer
ERROR#043
while "last mic on" mode is set to manual.
This error occurs as the result of an
tries to enable chairman mode, but the chairman microphone is set to a microphone that
ERROR#044
does not belong to the specified automixer.
This error occurs as the result of an
tries to set the chairman microphone to a microphone that does not belong to the specified
ERROR#045
automixer while chairman mode is enabled.
or FPLOCK, but invalid password given.
NVLOCK
AMASGN
AMASGN
AMLMM
AMLMN
AMCHAIR
AMCHAIR
Status Message
B01DSPLOADx , where x is between 0 and 99
and indicates the percentage of the variable
DSP resources being used.
or FPLOCK.
NVLOCK
command. It happens when the command
command. It happens when the command
command. It happens when the command
command. It happens when the command
command. It happens when the command
command. It happens when the command