Gainsot -- Set To Phone User Tone Gain; Gate -- Query Gating Status Information - Polycom Vortex EF2241 Programming Manual

Example Description
B01GAINSIT6 Set tone output gain to 6 dB.
B01GAINSIT>3 Increase tone output gain by 3 dB.
B01GAINSIT? Query tone output gain.

8.64. GAINSOT -- Set To Phone User Tone Gain

This command sets the gain of the user tones coming from the phone DSP. User tones include entry and exit
tones (see TONEE) and custom tones (see the
are played out "locally" and their gains are adjusted by the
played out to the phone, and the gain is adjusted by the GAINSOT command.
This command is an integer command. See
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAINSOT6 Set tone output gain to 6 dB.
B01GAINSOT>3 Increase tone output gain by 3 dB.
B01GAINSOT? Query tone output gain.

8.65. GATE -- Query Gating Status Information

This command is used to query the gating status of the microphone inputs. The command can be used to
query the status of individual microphones, or the wildcard character can be used to query the status of all
the microphone inputs.
The can be used to have gating information sent automatically instead of having to poll this
GATEEN
command.
Also see the command, which only reports microphones that have been gated on for a specified hold
CGATE
time.
Status Message
B01GAINSIT6
B01GAINSITx where x is the new value of the tone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINSIT9 .
B01GAINSITx , where x is the new value of the tone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINSIT9 .
and
SOUNDP SOUNDL
GAINSIT
Section 6.2 for more information on this type of command. The
Status Message
B01GAINSOT6
B01GAINSOTx , where x is the new value of the tone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINSOT9 .
B01GAINSOTx , where x is the new value of the tone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINSOT9 .
commands). In most cases, the tones
command. Sometimes, the tones are