Swreset -- Perform Soft Reset Of System; Swver -- Query Software Version; Tonee -- Enable Or Disable Entry And Exit Tones - Polycom Vortex EF2241 Programming Manual

B01SSTEXT0,1,?

8.154. SWRESET -- Perform Soft Reset of System

Executing this command causes the Vortex to perform a software reset. The effect of the software reset is
similar to cycling the power.
Example Description
B01SWRESET Perform a software reset.

8.155. SWVER -- Query Software Version

This command is used to query the firmware version of the Vortex.
Example Description
B01SWVER? Query current software version.

8.156. TONEE -- Enable or Disable Entry and Exit Tones

This command sets or queries the enabled status of the entry and exit tone feature. If entry and exit tones
are enabled, a specific tone is played whenever the auto-answer feature takes the phone off-hook. A
different tone is played whenever the auto-hangup feature puts the phone on-hook. This feature is typically
enabled to prevent a caller from entering or exiting a conference unannounced.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01TONEE1 Enable auto entry and exit tones.
B01TONEE0 Disable entry and exit tones.
B01TONEE2 Toggle enabled status of entry and exit tones.
B01TONEE? Query enabled state of entry and exit tones.
Query the text of the
second line of the first
screen.
Status Message
No status message will be received. The Vortex will reset within a
few seconds.
Status Message
B01SWVER<string> , where <string> is the current
sofware version. If the software version was 2.5.0, then the
status message would be B01SWVER2.5.0 .
Section 6.1 for more information on this type of command.
B01SSTEXT0,1,<string> , where <string>
is the text of the second line of the first screen. If
this command was issued after the example
above, then the status message would be
B01SSTEXT0,1,funky music .
Status Message
B01TONEE1
B01TONEE0
B01TONEEx , where x is 0 or 1 depending on
the current enabled state of entry and exit
tones.
B01TONEEx , where x is 0 or 1 depending on
the current enabled state of entry and exit
tones.