Phantom -- Enable Phantom Power On Inputs - Polycom Vortex EF2241 Programming Manual

This command has the same format and restrictions as the
parameter, the filter type, is specified instead of all the parameters. See the
information. To set the slope parameter for an input parametric EQ filter, use the
all the parameters for an input parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Set the type of the parametric EQ on
B01PEQOT3,2,1
output 3 , band 2 to parametric.
Query current type setting of
B01PEQOTB,1,?
parametric EQ on output B , band 1.

8.132. PHANTOM -- Enable Phantom Power on Inputs 1-4

This command sets or queries the status of phantom power on each of the microphone inputs.
This command is a channel boolean command. See
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example
B01PHANTOM21
B01PHANTOM20
B01PHANTOM22
B01PHANTOM2?
B01PHANTOM*0
B01PHANTOM*1
B01PHANTOM*2
Description
Enable phantom power for input
channel 2 .
Disable phantom power for input
channel 2 .
Toggle phantom power state for
input channel 2 .
Query state of phantom power
for input channel 2 .
Disable phantom power for input
channels 1-4.
Enable phantom power for input
channels 1-4.
Toggle phantom power for input
channels 1-4.
command except that only one
PEQOA
command.
PEQIA
Status Message
B01PEQOT3,2,1
B01PEQOTB,1,t , where t is the current setting
of the type parameter for the parametric EQ on
output B , band 1. If the type parameter of this
filter is set to the same value given in the example
above, then the status message will be
B01PEQOTB,1,1 .
Section 6.3 and Section 6.1
Status Message
B01PHANTOM21
B01PHANTOM20
B01PHANTOM2x , where x is 0 or 1 depending on
the current state of phantom power on input
channel 2 .
B01PHANTOM2x , where x is 0 or 1 depending on
the current state of phantom power on input
channel 2 .
B01PHANTOM*0000
B01PHANTOM*1111
B01PHANTOM*abcd where a-d are each 0 or 1
depending on the current state of phantom power
for the corresponding input channel.
command for more
PEQOA
command. To set
PEQIT
for more information on this