Fadergil -- Set Fader Gain Of Line Inputs As A Group - Polycom Vortex EF2241 Programming Manual

B01ERROR0 Disable error messages mode. B01ERROR0
B01ERROR2 Toggle error message mode.
B01ERROR? Query the state of error mode.

8.47. FADERGIL -- Set Fader Gain of Line Inputs as a Group

This command sets the fader gains of all the line inputs simultaneously. This is different from using a
wildcard, * with the
FADERI
while the FADERGIL sets only the line inputs.
This command will generate acknowledgements from each of the line inputs separately.
This command is an integer command. See
minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01FADERGIL7 Set fader gain of all line inputs to 7 dB.
Increase fader gains on all line inputs
B01FADERGIL>3
by 3 dB.
B01FADERGIL? Query fader gains on all line inputs.
B01ERRORx , where x is 0 or 1 depending on the current
state of error mode.
B01ERRORx , where x is 0 or 1 depending on the current
state of error mode.
command because that command sets all the mic and line inputs together,
Section 6.2 for more information on this type of command. The
Status Message
B01FADERIA7
B01FADERIB7
B01FADERIC7
B01FADERID7
B01FADERIAa
B01FADERIBb
B01FADERICc
B01FADERIDd ,
where a, b, c, and d are the new values of the
fader gains for each of the line inputs. If this
command was issued after the example above,
then the status messages would be:
B01FADERIA10
B01FADERIB10
B01FADERIC10
B01FADERID10 .
B01FADERIAa
B01FADERIBb
B01FADERICc
B01FADERIDd ,
where a, b, c, and d are the new values of the
fader gains for each of the line inputs. If this
command was issued after the example above,
then the status messages would be:
B01FADERIA10
B01FADERIB10
B01FADERIC10
B01FADERID10 .