Country -- Specify Country Definitions For Phone Interface; Delayo -- Set Output Delay - Polycom Vortex EF2241 Programming Manual

Query camera gating hold.
B01CGATET?
8.40. COUNTRY -- Specify Country Definitions for Phone
Interface
This command is used to set or query the country that the Vortex is configured for operation in. The country
setting affects parameters associated with the phone interface including transmit and receive impedances,
flash hook timing, timing thresholds for detecting hangup based on loop current drop, timing thresholds for
detecting incoming rings, and outgoing DTMF levels.
The following table lists the numeric values for this command and the associated countries.
Command Value
0
1
More countries will be added as the Vortex is approved for operation in other countries.
This command is an integer command. See
minimum and maximum values for this command are 0 and 1, respectively.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
time it is changed. It will retain its value after power-down. Since this command writes to non-volatile
memory, there will be a delay before an acknowledgment is returned.
Example Description
B01COUNTRY1 Set country definition to USA. B01COUNTRY1
B01COUNTRY? Query current country setting.

8.41. DELAYO -- Set Output Delay

This command sets the amount of output delay (in tenths of milliseconds) on each of the ten output
channels (1-4, A-D, T, L) . Use of the wildcard character (*) for specifying the channel is not supported for
this command. The output delay can be separately enabled or disabled via the
This command is an integer command. See
minimum and maximum values for this command are 0 and 3400, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01CGATETx , where x is between 100 and 5000
depending on the current setting of CGATET. If
this command is issued after the example above,
the status message will be B01CGATET1000 .
Section 6.2 for more information on this type of command. The
Status Message
B01COUNTRYx , where x is one of the numbers in the
above table that corresponds to the current country setting.
Section 6.2 for more information on this type of command. The
Status Message
Country
Undefined
USA
command.
DELAYOE