Gaind -- Set Gain Of Incoming Dtmf Tones; Gaindit -- Set Gain Of Incoming Dtmf Tones - Polycom Vortex EF2241 Programming Manual

B01GAINA? Query phone input gain.

8.55. GAIND -- Set Gain of Incoming DTMF Tones

This command sets the gain of the incoming DTMF tones. The gain of the outgoing DTMF depends on the
country that the Vortex is configured for (see the COUNTRY) command. This command is an alias for the
command. It is provided for backwards compatibility with and ease of migration from the EF200.
GAINDIT
When possible, the
GAINDIT
This command is an integer command. See
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAIND6 Set incoming DTMF gain to 6 dB.
B01GAIND>3 Increase incoming DTMF gain by 3 dB.
B01GAIND? Query incoming DTMF gain.

8.56. GAINDIT -- Set Gain of Incoming DTMF Tones

This command sets the gain of the incoming DTMF tones. The gain of the outgoing DTMF depends on the
country that the Vortex is configured for (see the COUNTRY) command.
This command is an integer command. See
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAINDIT6 Set incoming DTMF tone gain to 6 dB.
Increase incoming DTMF tone gain by 3
B01GAINDIT>3
dB.
command should be used instead of this command.
Section 6.2
Section 6.2
B01GAINAx , where x is the new value of the phone
input gain. If this command was issued after the
example above, then the status message would be
B01GAINA9 .
for more information on this type of command. The
Status Message
B01GAIND6
B01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was issued
after the example above, then the status message
would be B01GAIND9 .
B01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was issued
after the example above, then the status message
would be B01GAIND9 .
for more information on this type of command. The
Status Message
B01GAINDIT6
B01GAINDITx , where x is the new value of
the incoming DTMF tone gain. If this command
was issued after the example above, then the
status message would be B01GAINDIT9 .