Ssdelay -- Set Delay Between Screen Saver Screens; Ssen -- Enable Or Disable Screen Saver; Ssstart -- Set Idle Time Required For Screen Saver To Start - Polycom Vortex EF2241 Programming Manual

B01SOUNDP1 Play "descending thirds" sound (same as exit tone) to phone output.

8.150. SSDELAY -- Set Delay Between Screen Saver Screens

This command sets or queries the amount of time (in milliseconds) between each new screen of the LCD
screen saver.
This command is an integer command. See
minimum and maximum values for this command are 500 and 600000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Set screen saver delay to 2
B01SSDELAY2000
seconds (2000 ms).
Increase screen saver delay by 0.5
B01SSDELAY>500
seconds (500 ms).
Query screen saver delay.
B01SSDELAY?

8.151. SSEN -- Enable or Disable Screen Saver

This command controls whether or not the LCD screen saver is enabled.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01SSEN1 Enable screen saver.
B01SSEN0 Disable screen saver.
B01SSEN2 Toggle screen saver enabled state.
B01SSEN? Query screen saver enabled state.
8.152. SSSTART -- Set Idle Time Required for Screen Saver to
Start
Section 6.2 for more information on this type of command. The
Status Message
B01SSDELAY2000
B01SSDELAYx , where x is the new value of the
screen saver delay. If this command was issued
after the example above, then the status message
would be B01SSDELAY2500 .
B01SSDELAYx , where x is the new value of the
screen saver delay. If this command was issued
after the example above, then the status message
would be B01SSDELAY2500 .
Section 6.1 for more information on this type of command.
Status Message
B01SSEN1
B01SSEN0
B01SSENx , where x is 0 or 1 depending on the current
enabled state of the scrren saver.
B01SSENx , where x is 0 or 1 depending on the current
enabled state of the scrren saver.
B01SOUNDP1