Dial -- Send Dtmf Digits To Phone Interface; Dspauto -- Enable Automatic Dspload Status Messages; Dspload -- Query Percentage Of Variable Dsp Resources Used - Polycom Vortex EF2241 Programming Manual

B01DELAYOE*2
B01DELAYOE*?

8.43. DIAL -- Send DTMF Digits to Phone Interface

This command dials the specified string of digits by sending the equivalent DTMF tones to the phone
interface. Valid digits are '0'-'9', '*', '#', and ',' (delay). If the phone is not off-hook when this command is
executed, it will automatically be taken off-hook.
Example
B01DIAL9,,,4048921180

8.44. DSPAUTO -- Enable Automatic DSPLOAD Status Messages

This command sets or queries whether or not
the DSP utilization changes.
This command is a boolean command. See
Example Description
B01DSPAUTO1 Enable automatic DSPLOAD messages.
B01DSPAUTO0 Disable automatic DSPLOAD messages.
B01DSPAUTO2 Toggle automatic DSPLOAD messages.
Query the value of the DSPAUTO
B01DSPAUTO?
parameter.
8.45. DSPLOAD -- Query Percentage of Variable DSP Resources
Used
This command queries the current percentage used of the available variable DSP resources. When this
number reaches 100 percent, no more variable DSP veatures may ben enabled. An 'ERROR#060' will be
Toggle enabled status
of output delay on all
outputs.
Query enabled status of
output delay on all
outputs.
Description
Dial 9 (to get an outside line), then pause (the three
commas), then dial 4048921180.
DSPLOAD
Section 6.1
B01DELAYOE*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01DELAYOE*0000111101 .
B01DELAYOE*abcdefghij , where each of the
letters (a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on the
corresponding output. If this command was sent
after the example above, then the status message
would be B01DELAYOE*0000111101 .
messages will be automatically generated whenever
for more information on this type of command.
Status Message
B01DSPAUTO1
B01DSPAUTO0
B01DSPAUTOx , where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
B01DSPAUTOx , where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
Status Message
B10DIAL