Delayoe -- Enable Output Delay - Polycom Vortex EF2241 Programming Manual

B01DELAYO21500
B01DELAYO2>1700
B01DELAYO2?

8.42. DELAYOE -- Enable Output Delay

This command sets or queries the enabled state of the output delay for each of the ten output channels (1-4,
A-D, T, L) .
This command is a channel boolean command. See
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example
B01DELAYOE41
B01DELAYOEA0
B01DELAYOEL2
B01DELAYOEC?
B01DELAYOE*1
B01DELAYOE*0
B01DELAYOE*1111000010
Set output delay on output channel
2 to 150 ms (1500 tenths of
milliseconds).
Increase output delay on output
channel 2 by 170 ms (1700 tenths
of milliseconds.)
Query current output delay on
output channel 2 .
Description
Enable output delay on
output 4 .
Disable output delay on
output A .
Toggle enabled status
of output delay on
output L .
Query enabled status of
output delay on output
C .
Enable output delay on
all outputs (1-4, A-D, T,
L) .
Disable output delay on
all outputs (1-4, A-D, T,
L) .
Enable output delay on
outputs 1-4 and T, and
disable output delay on
outputs A-D and L.
B01DELAYO21500
B01DELAYO2x , where x is between 0 and 3400
depending on the current output delay setting for
output channel 2 . If this command is issued
after the above example, then the status
message will be B01DELAYO23200 .
B01DELAYO2x , where x is between 0 and 3400
depending on the current output delay setting for
output channel 2. If this command is issued after
the above example, then the status message will
be B01DELAYO23200 .
Section 6.3 and Section 6.1
Status Message
B01DELAYOE41
B01DELAYOEA0
B01DELAYOETx , where x is either 0 or 1
depending on the current enabled status of the
output delay on the output.
B01DELAYOECx , where x is either 0 or 1
depending on the current enabled status of the
output delay on the output.
B01DELAYOE*1111111111
B01DELAYOE*0000000000
B01DELAYOE*1111000010
for more information on this