Lagc -- Enable Or Disable Line Input Automatic Gain Control - Polycom Vortex EF2241 Programming Manual

PM0-PM1, WM0-WM2, XM0-XM2, YM0-YM2,
ZM0-ZM2
R1, R2
G0-G3
LI1-LI24
LO1-LO20
P0-P47
M0-M255
The text of each label can be up to 16 characters long. Labels for presets 0-15 are read-only.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved each
time it is changed. It will retain its value after power-down. Since this command writes to non-volatile
memory, there will be a delay before an acknowledgment is returned.
Example
B01LABELOB,Zone 2 Speaker
B01LABELOB,?
8.70. LAGC -- Enable or Disable Line Input Automatic Gain
Control
This command sets or queries the status of the Automatic Gain Control (AGC) algorithm on input channels A-
D .
This command was introduced in firmware version 2.5.0.
This command is a channel boolean command. See
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01LAGCB1 Enable AGC on input channel B.
B01LAGCA0 Disable AGC on input channel A.
B01LAGCC2 Toggle AGC state on input channel C .
B01LAGCD? Query AGC state on input channel D .
B01LAGC*1 Enable AGC on input channels A-D.
B01LAGC*0 Disable AGC on input channels A-D.
Labels for outputs from EF Bus submatrices to main
matrix.
Labels for AEC references.
Labels for logic input groups.
Labels for logic input pins
Labels for logic output pins
Labels for user presets.
Labels for user macros.
Description
Set label of output B to
"Zone 2 Speaker".
Query label for output B
.
Section 6.3
Status Message
B01LAGCB1
B01LAGCA0
B01LAGCCx , where x is 0 or 1 depending on the
current state of the AGC on input channel C .
B01LAGCDx , where x is 0 or 1 depending on the
current state of the AGC on input channel D .
B01LAGC*1111
B01LAGC*0000
Status Message
B01LABELOB,Zone 2 Speaker
B01LABELOB,<string> , where <string>
is the current label assigned to output B .
and Section 6.1 for more information on this