Gainp -- Set Phone Output Gain; Gainsit -- Set From Phone User Tone Gain - Polycom Vortex EF2241 Programming Manual

B01GAINO*ääääììììçç
B01GAINO*?

8.62. GAINP -- Set Phone Output Gain

This command sets the gain of the output to the phone interface. This command is an alias for the GAINOT.
It is provided for backwards compatibility with and ease of migration from the EF200. When possible, the
command should be used instead of this command.
GAINOT
This command is an integer command. See
minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
B01GAINP6 Set phone output gain to 6 dB.
B01GAINP>3 Increase phone output gain by 3 dB.
B01GAINP? Query phone output gain.

8.63. GAINSIT -- Set From Phone User Tone Gain

This command sets the gain of the user tones coming from the phone DSP. User tones include entry and exit
tones (see TONEE) and custom tones (see the
are played out "locally" and their gains are adjusted by the GAINSIT command. Sometimes, the tones are
played out to the phone, and the gain is adjusted by the
This command is an integer command. See
minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Set gain on output
channels 1-4 to 0 dB, gain
on output channels A-D to
9 dB, and gain on
telephone output T and
power amplifier L to 3 dB.
Query gain settings on all
output channels (1-4, A-
D, T, L) .
Section 6.2
SOUNDP
Section 6.2
B01GAINO*ääääììììçç
B01GAINO*abcdefghij, where a-j are each
between <space> and ÿ, depending on the current
setting of the gains for each of the ten output
channels (1-4, A-D, T, L).
for more information on this type of command. The
Status Message
B01GAINP6
B01GAINPx , where x is the new value of the phone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINP9 .
B01GAINPx , where x is the new value of the phone
output gain. If this command was issued after the
example above, then the status message would be
B01GAINP9 .
and commands). In most cases, the tones
SOUNDL
command.
GAINSOT
for more information on this type of command. The