Peqoe -- Set Enabled Parameter For Specified Parametric Eq Output Stage; Peqof -- Set Frequency Parameter For Specified Parametric Eq Output Stage - Polycom Vortex EF2241 Programming Manual

Query current bandwidth setting of
parametric EQ on output B , band
B01PEQOBB,1,?
1.
8.127. PEQOE -- Set Enabled Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the enabled parameter (0 = filter is disabled, 1 = filter is enabled) for the
parametric equalizer (EQ) filters on output channels 1-4, A-D, T, and L . Each channel has five bands of
parametric EQ that can be independently controlled.
This command has the same format and restrictions as the
parameter, the enabled status, is specified instead of all the parameters. See the
information. To set the enabled parameter for an input parametric EQ filter, use the
all the parameters for an intput parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Enable parametric EQ on output 3 ,
B01PEQOE3,2,1
band 2.
Query enabled status of parametric
B01PEQOEB,1,?
EQ on output B , band 1.
8.128. PEQOF -- Set Frequency Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the frequency parameter (in Hz) for the parametric equalizer (EQ) filters on
output channels 1-4, A-D, T, and L . Each channel has five bands of parametric EQ that can be independently
controlled.
The minimum and maximum values for the frequency parameter are 20 and 20000, respectively.
For filter types that have a center frequency (e.g., parametric), this parameter specifies the center
frequency. For filter types that have a cutoff frequency (e.g, highpass, lowpass, etc.), this parameter
specifies the cutoff frequency.
This command has the same format and restrictions as the
parameter, the frequency, is specified instead of all the parameters. See the
B01PEQOBB,1,b , where b is the current setting
of the bandwidth parameter for the parametric EQ
on output B , band 1. If the bandwidth parameter
of this filter is set to the same value given in the
example above, then the status message will be
B01PEQOBB,1,40 .
command except that only one
PEQOA
command.
PEQIA
Status Message
B01PEQOE3,2,1
B01PEQOEB,1,e , where e is the current setting
of the enabled parameter for the parametric EQ
on output B , band 1. If the enabled parameter of
this filter is set to the same value given in the
example above, then the status message will be
B01PEQOEB,1,1 .
command except that only one
PEQOA
PEQOA
command for more
PEQOA
command. To set
PEQIE
command for more