Amgatet -- Set Automixer Gate Threshold - Polycom Vortex EF2241 Programming Manual

B01AMGATER*12
B01AMGATER*ÉÉôô
B01AMGATER*<3
B01AMGATER*?

8.19. AMGATET -- Set Automixer Gate Threshold

This command sets the automixer gate threshold (in dB) for the specified input channel. The gate threshold
is the level that the input signal must reach in order to gate the microphone on. This value us only used if
the input is set to manual gating via the
This command is a channel integer command. See
type of command. The minimum and maximum values for this command are 0 and 100, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example
B01AMGATET312
B01AMGATET3>3
B01AMGATET3?
B01AMGATET*12
Set gate ratio for automatic
gating threshold to 12 dB for all
input channels.
Set gate ratio for automatic
gating threshold to 12 dB for
inputs 1-2 and 15 dB for inputs 3-
4.
Decrease gate ratio for automatic
gating threshold by 3 dB for all
input channels.
Query gate ratio for automatic
gating threshold for all input
channels.
AMAUTO
Description
Set gate threshold for manual
gating threshold to 12 dB for
input channel 3 .
Increase gate threshold for
manual gating threshold by 3 dB
for input channel 3 .
Query gate threshold for manual
gating threshold for input
channel 3 .
Set gate threshold for manual
gating threshold to 12 dB for all
input channels.
B01AMGATER*ÉÉÉÉ
B01AMGATER*ÉÉôô
B01AMGATER*abcd , where a-d will each be
between ä and
gate ratio for each input channel. If this command
is issued after the example above, the status
message will be B01AMGATER*ììÉÉ .
B01AMGATER*abcd , where a-d will each be
between ä and
gate ratio for each input channel. If this command
is issued after the example above, the status
message will be B01AMGATER*ììÉÉ .
command.
Section 6.3 and Section 6.2
Status Message
B01AMGATET312
B01AMGATET3x , where x is between 0 and 100
depending on the current setting of the gate
threshold for input channel 3 . If this command is
issued after the example above, then the status
message will be B01AMGATET315 .
B01AMGATET3x , where x is between 0 and 100
depending on the current setting of the gate
threshold for input channel 3 . If this command is
issued after the example above, then the status
message will be B01AMGATET315 .
B01AMGATET*ÉÉÉÉ
depending on the setting of the
depending on the setting of the
for more information on this