Amauto -- Select Automatic Or Manual Gating For Each Automixer Input - Polycom Vortex EF2241 Programming Manual

This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Assign input 3 to automixer #1.
B01AMASGN31
Query current automixer
B01AMASGN3?
assignment for channel 3 .
Assign all mic inputs to no
B01AMASGN*0
automixer.
Assign inputs 1-2 to automixer #1
B01AMASGN*ààåå
and inputs 3-4 to automixer #2.
Query automixer assignment for all
B01AMASGN*?
mic/line input channels.
8.12. AMAUTO -- Select Automatic or Manual Gating for each
Automixer Input
This command selects or queries the state of automatic or manual automixer gating thresholds for the
specified input channel. Automatic thresholds mean that the automixer adaptively determines the gating
thresholds based on current speech and noise levels using the gating ratio specified by the
command. Manual thresholds mean that the automixer uses the absolute threshold set via the
command.
This command is a channel boolean command. See
type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Select automatic thresholds for
automixer gating on input channel 3
B01AMAUTO31
.
Select manual thresholds for
automixer gating on input channel 3
B01AMAUTO30
.
Toggle between automatic and
manual thresholds for automixer
B01AMAUTO32
gating on input channel 3 .
Status Message
B01AMASGN31
B01AMASGN3x , where x is 0, 1, or 2 depending
on the current automixer assignment for channel 3
. If this command is issued after the example
above, then the status message will be
B01AMASGN31 .
B01AMASGN*ääää
B01AMASGN*ààåå
B01AMASGN*abcd , where each of the letters (a,
b, etc.) is either ä, à, or å depending on the
current automixer assignment for each channel. If
this command is issued after the example above,
then the status message will be B01AMASGN*ààåå
.
Section 6.3 and Section 6.1
Status Message
B01AMAUTO31
B01AMAUTO30
B01AMAUTO3x , where x is 0 or 1 depending on
whether input channel 3 is currently set for manual or
automatic thresholds.
AMGATER
AMGATET
for more information on this