Connecting Rf Input From A Generator - Advanced Energy VarioMatch Match Network VM 1000 Platform User Manual

The Water In and Water Out connectors are brass hose connectors on the side panel
1. Install the user-supplied water lines to WATER IN and WATER OUT. See the
GENERATOR connector on the match network.
The RF-GENERATOR connector is a 50 Q N-type connector.
RF-GENERATOR connector, and
Advanced Energy ®
,&CAUTION:
When fastening the water hose, be sure the bullkhead does not rotate;
this could cause internal damage to the unit.
If your unit is not water-cooled, skip this section.
of the V arioMatch match network. The V arioMatch match network includes the water
fitting (see Figure
ID). The VarioMatch match network water cooling system does not include water
solenoid, water flow meter, or humidity sensor. You must take external measures to
protect the unit and the environment.
To Connect Cooling Water:
SERTO
®
to the water fitting.
2. Ensure you meet all cooling requirements (see
page 5-2).
3. Leak-check the water connections.
Figure 5-2. Water fitting for plastic hose with 6
0.16" ID)
Connecting RF I nput From a Generator
Connect the user-supplied coaxial cable from the generator's RF output to the RF­
5-8
5-2) for plastic hoses with 6 mm OD
documentation for instructions on properly connecting the water lines
Table 5-1
Installation, Setup, and Operation
/ 4 mm ID (0.24" OD
"Cooling Requirements" on
mm OD I 4 mm ID (0. 24" OD I
Figure 5-3
describes the input connector pins.
57020080-00D
/ 0.16"
shows the