Mounting The Unit; General Mounting Instructions; Grounding The Unit - Advanced Energy VarioMatch Match Network VM 1000 Platform User Manual

_& CAUTION:
2. "Connecting the Match INTERFACE (Optional)" on page 5-7
3. "Connecting the Cooling Water" on page 5-7
4. "Connecting RF Input From a Generator" on page 5-8
5. "Connecting to the Load" on page 5-9
6. "Connecting AC Input (Mains) Power" on page 5-11

Mounting the Unit

GENERAL MOUNTING INSTRUCTIONS

Do not mount on hot tool; excessive temperatures can cause
components to overheat and fail.
When mounting the V arioMatch match network, keep in mind the following:
• Mount the VarioMatch match network as close as possible to the load, leaving
room to access all connectors and to open the top panel. See
Specifications" on page 3-1
• Ensure the unit will remain within the specified operating temperatures. See
"Cooling Specifications" on page
• Ensure that exhausted air does not circulate back into the unit to become input air.
• Install the V arioMatch match network so that the cooling fan is facing up.
• Position the unit so
install another suitable disconnecting device
and other applicable requirements of EN 61010-1.
•
Ensure proper grounding (see
•
Mount the VarioMatch match network (see
Network" on page

GROUNDING THE UNIT

_&W ARNJNG:
Do not attempt to turn on power until the VarioMatch match network is
grounded.
57020080-00D
AE VarioMatch Match Network, VM 1 000/1 500 Platform
TM
for dimensions and spacing requirements.
3-14.
that it is easy to unplug the AC input power cord, unless you
"Grounding the Unit" on page
5-6).
Installation, Setup, and Operation
"Physical
that complies with the accessibility
5-5).
"Mounting the VarioMatch Match
5-5