Tools Required For Installation; Unpacking; Cooling Requirements - Advanced Energy VarioMatch Match Network VM 1000 Platform User Manual

Advanced Energy ®

COOLING REQUIREMENTS

Ensure that exhausted air does not circulate back into the unit and become input
Also, ensure that all cooling requirements are within specification. See
Specifications" on page
Tools Required for I nstallation
AE supplies the following equipment:
• Two AC MAINS cables. Use the cable appropriate to your location.
• If the PLASMA/LOAD connector on your V arioMatch match network is MC6 or
6 mm brass tube fittings, AE supplies the matching plug. See the
Specifications" on page 3-1
uses.
For successful installation, you will need to supply the following additional
equipment:
• Four M6 mounting screws (preferably brass) and an appropriate screwdriver.
• If the PLASMA/LOAD connector on your V arioMatch match network is a strap
connection, you need to supply the strap connector and the ground strap. See the
"Physical Specifications" on page 3-1
your unit uses.
•
For water-cooled units: Plastic hose 6 mm
(see "Connecting the Cooling Water" on page
•
Cables (see also
► Shielded 50
► RF cabling to connect the unit to a generator. See
page 5-3.
► Communication interface cable if you will use remote control of the unit.
•
If you purchased an ICP unit, you must supply the tune coil. See the
Specifications" on page 3-1

Unpacking

Unpack and inspect the unit carefully, looking for obvious physical damage. If no
damage is apparent, proceed with the installation. If you do see signs of shipping
damage, contact Advanced Energy
Global Services" on page
claims to the carrier.
5- 2
3-14.
to see which PLASMA/LOAD connector your unit
to see which
"Connector/Cable specifications" on page
n
coaxial cable for RF input from the generator
to see if your unit is ICP.
and the carrier immediately (see
®
6-4). Save the shipping container for submitting necessary
Installation, Setup, and Operation
"Cooling
"Physical
PLASMA/LOAD
OD / 4 mm ID (0.24" OD/ 0.16" ID)
5-7).
3-3):
"Cable Requirements" on
"Physical
"Contacting AE
57020080-00D
air.
connector