Match Interface Using Switches; Table 4-2. Match Interface Switch Descriptions - Advanced Energy VarioMatch Match Network VM 1000 Platform User Manual

User supplied c i rcui!Jy
-
may vary
Figure 4-7. Pin 15

Match INTERFACE Using Switches

To construct a simple manual control, wire four normally open momentary switches
for the motor drive and one on/off switch for
below.

Table 4-2. Match INTERFACE switch descriptions

Momentary Motor
switch drive
Common connection of all 5 switches (Ground)
Switch 1 motor 1
Switch 2 motor 1
Switch 3 motor 2
Switch 4 motor 2
Switch 5 (on/ Manual/
oft) Auto
Connect the switch box to the match
should be connected to ground at pin 1 of the D-connector. To avoid a ground loop,
which could result in erratic operation of the remote control, do not
shield to any other ground in the system.
57020080-00D
INTERFACE
AE VarioMatch
TM
I
I
Internal circu
I
I
I
I
I
I
9 1-- - ...
Gnd
Results
run clockwise
run counter
clockwise
run clockwise
run counter
clockwise
Selects Manual or Auto mode
Communication Interfaces and Controls
Match Network, VM 1000/1500 Platform
try
i
CD4001 B
(NOR Gate)
auto/manual mode selection as described
INTERFACE
1
decrease C e
2
nm
increase Cnme 3
decrease C
4
Load
increase C
5
Load
8
using a shielded cable. The shield
connect
Connect to
Pin #
the cable
4-7