Advanced Energy VarioMatch Match Network VM 1000 Platform User Manual page 13

Figure 2-1. Theory of operation ........................................... 2-3
Figure 2-2. L match network circuit ........................................ 2-5
Figure 2-3. VarioMatch L match network circuit .............................. 2-5
Figure 2-4. Gamma topology ............................................ 2-7
Figure 2-5. L match topology ............................................ 2-7
Figure 3-1 . VM 1000/1500 platform front panel .............................. 3-1
Figure 3-2. VM 1000/1500 platform left side panel ............................ 3-2
Figure 3-3. VM 1000/1500 platform rear panel ............................... 3-3
Figure 3-4. VM 1000/1500 platform bottom panel ............................. 3-4
Figure 3-5. VM 1000/1500 platform top panel ................................ 3-5
Figure 4-1. VarioMatch match INTERFACE connector ......................... 4-1
Figure 4-2. Pins 2, 3, 4, 5, 8 ............................................. 4-4
Figure 4-3. Pin 10 ..................................................... 4-5
Figure 4-4. Pin 11 ..................................................... 4-5
Figure 4-5. Pin 12 ..................................................... 4-6
Figure 4-6. Pins 13, 14 ................................................. 4-6
Figure 4-7. Pin 15 ..................................................... 4-7
Figure 5-1. Installing the VarioMatch match network to a mounting plate .......... 5-7
Figure 5-2. Water fitting for plastic hose with 6 mm OD / 4 mm ID (0.
5-8
Figure 5-3. N-type connector ............................................ 5-9
Figure 5-4. 7 /16 DIN female connector .................................... 5-1 O
Figure 5-5. MC6 connector ............................................. 5-1 O
Figure 5-6. MC6 plug ................................................. 5-10
Figure 5-7. 6 mm brass tube fitting ....................................... 5-11
Figure 5-8. Input (Mains) connector ...................................... 5-12
Figure 5-9. Tapping of the tune coil for small capacitive load ................... 5-20
Figure 5-1 O. Tapping of the tune coil for medium capacitive load ................ 5-21
Figure 5-11. Tapping of the tune coil for high capacitive load ................... 5-22
Figure 5-12. Tap position for small loads .................................. 5-24
Figure 5-13. Tap position for medium loads ................................ 5-25
Figure 5-14. Tap position for large loads .................................. 5-26
Figure 5-15. Alternate interconnector and bridge ............................ 5-29
Figure 5-16. Disconnect the original interconnection ......................... 5-30
Figure 5-17. Attach the new interconnector ................................ 5-31
Figure 5-18. Remove the front panel ..................................... 5-32
Figure 5-19. Remove solder joints ....................................... 5-33
Figure 5-20. Jumper setting for L match topology ............................ 5-34
Figure 5-21. Jumper setting for Gamma topology ............................ 5-35
Figure 5-22. Location of capacitor bank with three jumpers .................... 5-37
Figure 7-1 . Models 300, 1000, and 1500 coil and inductor schematic; 14 turn tune coil
7-1
57020080-00D
AE VarioMatch Match Network, VM 1000/1500 Platform
TM
List of Figures
List of Figures
24" OD / 0. 16" ID) .
xiii