Waybox Commissioning Through The Enel X Way App - Enel X Waybox Pro Installer Manual

REV.2 - 03/2023
10 Waybox Commissioning through the
Enel X Way App
1. Enel X Way partner can install the app of Enel X Way on his/her device by scanning QR
code below.
2. Once the Enel X Way Waybox™ has been installed, the Enel X Way partner must associate
it with his/her Enel X Way app account in the Waybox section of the main page of the
app and following the instructions on the screen.
3. After pairing the Enel X Way Waybox™ with its Enel X Way app account, the Enel X Way
partner must proceed to unpair it from the same, otherwise the Customer will not be
able to associate the Waybox on his/her account.. The Enel X Way partner can dissociate
the Waybox from their account by access Waybox section of the main page of the app
and by clicking on setting icon > unpair.
NOTE: To use the Enel X Way app, the charging station must be connected online and the
phone on which the app is installed must have Internet connectivity available.
NOTE: In case of installation of a three-phase Waybox in single-phase mode, before
commissioning the Waybox, it will be necessary to perform the configuration presented at
paragraph 7.1.
NOTE (Waybox Pro and Waybox Pro Cellular): If a Waymeter is installed to enable the Load
Optimization Pro feature, the maximum power delivered by the Waybox will correspond to
the minimum between the power limit configured during Waymeter installation and the
power level selected through the Enel X Way app.
38