Table of Contents
Advertisement
6 Standard Installation
The following is the standard installation procedure, valid for all versions of Waybox in this
manual. The procedure also includes optional steps, which must be carried out only in the
following cases:
>
Installation of a Waybox with control board.
>
Installation of an external antenna.
NOTE:
The Waybox must be installed by a qualified electrician.
1. Make sure no voltage is applied to the input cable.
WARNING
Do not continue this procedure until you are certain that no voltage is present at the
input cable.
2. When installing 4 mm
cable wires with the crimping tool.
NOTE:
When installing 10 mm
and 6 mm
cross-section cables, install the terminals on the input
2
2
cables, strip only the cables, do not install the terminals.
2
REV.2 - 03/2023
19
Advertisement
Table of Contents
Need help?
Do you have a question about the Waybox Pro and is the answer not in the manual?
Questions and answers