Stratasys J826 User Guide
4. Unscrew the cap securing the waste drain tube and connect it to the new
5. Close the full container with the cap supplied with the new waste
6. Close the new waste container box.
7. Position new the waste container in the printer.
8. Close the compartment door.
Dispose of the full waste container in accordance with environmental and
safety requirements.
The painted exterior plastic panels of the printer has a durable finish, offering
Cleaning the
excellent chemical resistance to common cleaning materials. Follow the
Exterior Panels
recommendations below when cleaning these areas of the printer.
Acceptable Cleaning Agents
• mild soap solution
• common household cleaners and window cleaners
• common commercial and industrial detergents, 5% solution in water
• alcohol (ethanol, isopropanol), 10% to 40% solution in water
Wipe the exterior of the printer, using a soft cloth moistened with the
cleaning solution.
Unacceptable Materials
• industrial solvents
• cleaning agents containing hydrocarbons, ketones, esters and lacquer
thinners
• spray disinfectants
• abrasives and agents which could wear away the panel finish
DOC-28000 Rev. D
container.
container.
Note: The sealing cap contains an inner stopper that prevents leakage when
the cap is tightened. Do not be concerned that air can still flow through the
opening on the top of the cap, since the inner stopper seals the waste
container.
Figure 4-166 Waste container sealing cap
Note: Make sure that the waste drain tube is not crimped or twisted, and that
it is not pinched by the container.
4 Operating and Maintaining the Printer
4-108